Picaxe motion sensor board - uses the picaxe 08M chip so you can program it yourself!

Control a trail camera, or use it to control other electronics too.




HomeBrew Products

Instructions/tech info




image linking to 100 Top Hunting Sites
Vote for Us at The Outdoor Lodge's Top Hunting Sites

Click here for: Snapshot Sniper Game Camera Controller Operation

Click here for a "PICTURE TUTORIAL" building a camera with the Sony P41 in a Pelican 1010 case.

Click here for a hole template: "Simple Sniper Template" NOTE: Make very sure that the template prints the correct size before drilling any holes. The template should measure 2.8 inches by .65 inches. Don't go to "File, Print"....Use the print button on the Adobe Reader tool bar, and set the "Page Scaling" to "NONE" and you shouldn't have any problems.

Click here for: Programming Info

Click here for: Free Sample Programs

Features for Simple Sniper (For building your own trail cameras!)

-6 Month Parts and Labor Warranty
- Easy Setup: "Just 2 options. Either set it for use on a trail, or on a feeder; that's it, you are ready to go."
- Long battery life: at just 30 microAmps, one 9Volt battery will last over 1 year!
- “Walk test” mode When in this mode, the camera will not trigger and you will see an ultra bright LED light up when motion is detected to ensure proper alignment and distance.
- Programmable...literally. The board has a picaxe 08M chip. With a free program and an inexpensive programmer kit, you can modify and create your own program to control the camera, or other devices how you want.

Click here for: Programming Info

Click here for: Free Sample Programs